Best answer: How do you start a wood burning fireplace with a gas starter?

How do you use a gas log starter?

Just set the logs on the wood grate over the log lighter, turn the key to open the gas line, toss in a lit match, and the fire lights around your logs. After the logs have caught on fire, turn the valve key to close the gas line, and enjoy the crackling wood fire before you.

Can you leave gas starter on in fireplace?

For safety reasons you only want to turn the gas starter on right before you light it, leaving it on for too long allows gas to build up inside the fireplace, which will flare up once lit.

How long can you leave a gas starter on?

In short, you really shouldn’t let a gas fireplace on for too long—specifically more than three hours at a time.

Can you burn real wood in a gas starter fireplace?

A gas fireplace is unable to burn firewood as the fuel, either alongside gas or by itself, as gas fireplaces aren’t setup to burn wood safely and effectively. Many gas fireplaces have logs in the firebox but these aren’t real. A gas fireplace would need to be converted to a wood burning fireplace or stove to burn wood.

THIS IS IMPORTANT:  You asked: What's involved in being a firefighter?

Can I burn firewood in a gas fireplace?

Pro tip: Burning Wood Logs in a Gas Fireplace

Answer? Definitely not. Wood-burning units are meant to hold wood, while gas-fueled units are meant to host gas. Mixing fuel types could lead to fire hazards, smoke back-up, and a lot of damage to your home/unit.

Can I use a gas starter with gas logs?

You have to remove the gas logs and its gas burner pipe entirely and replace it with a real gas starter pipe that you can purchase from a stove shop or a hardware store. Then you can burn wood in your fireplace again.

How do you start a fire in a fireplace?

Start by placing two pieces of firewood on the grate in your fireplace. Now crumple newspaper, which is your tinder, and place it between the firewood. Place the kindling on top. Add one or two more pieces of firewood on top of the other logs, and be sure to leave enough room for air to circulate around the logs.

Why does my wood-burning fireplace have a key?

Lighting a Gas Fireplace With a Key Valve

You will control the gas flow with a fireplace key (sometimes called a hex key) as you light the fireplace. Place a long lighter next to the burner and pull the fuel trigger. (You can also use a lit match.) … The pilot should light immediately.

How do you clean a gas fireplace starter?

Remember to avoid any flammable cleaning ingredients when caring for your fireplace.

  1. Turn off the gas valve to the burners. …
  2. Run your vacuum cleaner’s hose attachment over the burners to collect loose buildup.
  3. Scrub stuck-on residue off of the burners, using a soft cleaning brush.
THIS IS IMPORTANT:  How much do firefighter/paramedics make in Illinois?

What’s a good fire starter?

The best fire starters tend to be made of environmentally friendly materials, be it wood waste (sawdust or shavings), non-toxic wax, recycled paper, or waste textile fibers.