Which one of the following will be used first on a fire in the engine room?

What is the first step if there is engine room fire?

Action in case of Engine Room fire at sea. Raise the alarm. Reduce the vessels speed & Engage manual steering. Display NUC ( NOT UNDER COMMAND) lights,Weather reports, open communication with other vessels in the vicinity and send urgency signal.

What are the steps to be done when there is fire inside the engine room?

As soon as a fire is detected, several actions should be taken to ensure the safety of the vessel and the personnel.

  1. General alarm should be sounded.
  2. Bridge team should be informed.
  3. Fire party should muster.
  4. The fire should be isolated, by closing ventilation system, skylights, doors, boundary cooling, etc.
THIS IS IMPORTANT:  Frequent question: How much does the fire Academy cost in California?

What type of fire extinguisher shall be used in the engine room?

Carbon Dioxide extinguisher

Carbon dioxide extinguishers are mainly used for class B or class C fires. They are not used for accommodation areas and confined spaces because of the gas used in lethal. These are widely used as engine room fire extinguisher.

What is the best firefighting system to use to extinguish fire that occurred in the engine room of an oil tanker?

The standard equipment used for fighting a fire in the engine room of a ship is hand-held fire extinguishers, a large capacity extinguisher, fire pumps and fire hoses, and the fixed fire extinguishing system.

What is engine room fire?

Engine room fires are often very challenging to deal with, due to the construction of the room and a plentiful supply of the fire triangle elements: heat, fuel and oxygen. A major engine room fire can have destructive consequences and, in the aftermath, it’s unlikely for a ship to continue under her own power.

Which of the action listed should be taken first to control and oil fire in a fuel oil tank?

Extinguishing: For tackling oil or organic fuel fires (petrol, diesel, kerosene), extinguishing foam is the only effective solution.

What is the first step when responding to a boat fire emergency?

Marine Fire Emergency: Response

Stop the engine immediately! This is always the first thing to do in case of a boat fire. Position your boat so that the wind blows the fire away from your boat. This will help prevent the fire from spreading and minimize smoke inhalation for you and your passengers.

THIS IS IMPORTANT:  Who completes a fire risk assessment NHS?

What is the first action of Master upon learning the incident on board ship?

1. Inform the Master and Engine room: This is obvious, but make sure you inform the Master, if he is not on bridge. Inform the engine room and stop the engine. The officer on watch should not hesitate to call the master even if he has the slightest doubt about any given situation.

What are the steps to be taken in the event of purifier room fire?

A purifier room is one of the most probable places in the engine room to catch fire.

In case of a bigger fire, the following steps should be taken:

  1. As soon as fire alarm is sounded, call the chief engineer and locate the fire.
  2. Close the quick closing valves from which the oil is leaking.
  3. Stop the transfer pump.

What are the 4 types of fire extinguishers?

There are four classes of fire extinguishers – A, B, C and D – and each class can put out a different type of fire.

  • Class A extinguishers will put out fires in ordinary combustibles such as wood and paper.
  • Class B extinguishers are for use on flammable liquids like grease, gasoline and oil.

What is DCP fire extinguisher?

DCP extinguishers are sodium bicarbonate and potassium bicarbonate. • DCP extinguishers puts out fire by. coating the fuel surface with chemical powder. • This separates the fuel from the. oxygen in the air and prevent vapor formation.

Which fire extinguisher is used for electrical fire?

Traditionally, CO2 extinguishers are used for electric equipment, as the CO2 gas does not carry electricity. However, CO2 gas can drift off and the fire can re-ignite.

THIS IS IMPORTANT:  Quick Answer: Can I use Thhn for fire alarm?

Which valve opens first for operating fixed CO2 system?

In the CO2 release cabinet, open pilot cylinder valve first. Now open valve 1 for master valve first. Then open valve 2 for CO2 releasing mechanism. Co2 will be released after 60-90 seconds of time delay.

When using foam a Class B fire is extinguished by?

Foam extinguishes Class A Fires by cooling the burning material and removing the heat from the combustion triangle. Foam extinguishes Class B Fires by covering the flammable liquid with a foam blanket, thus cutting off the oxygen supply from the combustion process.

How do you extinguish extensive fire with a fixed CO2 fire extinguisher?

Aim: Aim low, pointing the nozzle or hose at the base of the fire. Do not touch the horn on a CO2 extinguisher, it gets very cold and can damage the skin. Squeeze: Squeeze the handle to release the extinguishing agent. Sweep: Sweep from side to side at the base of the fire, the fuel source, until the fire is out.